rankrank1 said: (quoted from post at 12:08:42 04/18/15) All you people touting the WD45 hp numbers and specs need to go back and reread the Original Post again. It said "WD". No where in the OP did it say WD45. A WD is around 30 hp where a Farmall 300 is around 39 hp.
Sure a WD can be hopped up but so can a 300. Stock to stock there is no comparison.
And if anyone wants to slam the door closed on this comparison then lets discuss some operator ergonomics and comfort. The Farmall 300 has some comfort. The WD has absolutely NONE.
Wel if you really want to get picky my wd is getting a 45 crank oversize pistons, wider tires and cam work. The Farmall will be staying stock as far as I know at this point.
As for weight lets say they are both in the 4500 to 5000 pound weight class for pulling. The torque on the 300 works as well.
As for comfort the only thing I like about the 300 is the seat in the middle. The offset seat on the allis bugs me a little bit otherwise Its a toss up for me, other than the clutch being on the stiff side on the 300, and yes I do like the torque on the 300
This post was edited by blue924.9 at 12:23:25 04/18/15 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
