Posted by T.E.C. on April 16, 2015 at 18:39:45 from (24.241.158.246):
A few years ago I threw in the towel and closed my shop. I still wrench for a living but I don't get my old tractor fix very often anymore. I had a tractor on the dyno the other day and had a thought. We are always looking for extra work in the summer so why not give a good service and have some fun. Located in Marshfield, WI, we have a PTO dyno that we've decided to put to good use for our antique tractor pulling friends. It's 540 with a pulse damper for the 2 cylinder guys. I run it myself with experience with Marvel and Zenith carburetors, mag and distributors. As a former puller, tuning for that hidden power is no issue. The labor rate is 85 an hour and most dyno runs without tuning can be done in roughly 15 minutes. If timing or fuel needs adjustment, it seldom takes more than 45 minutes or so. Of course if there needs to be jet changes or diagnosis of very low power, it takes a bit more time. I'd like to get this service out there as a lot have forgotten us antique tractor lovers. Give us a ring at 715-387-1106.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Museum Coverage: The Stuttgart Agricultural Museum - by Cindy Ladage. While cold wind was blowing back in Illinois, in Arkansas, daffodils were in bloom, and the Magnolia trees were adorned with fragrant blossoms. Stuttgart, Arkansas was the site of this year's winter Minneapolis Moline Collector's show February 25-27, 1999. The show was held at the Oliver Museum created by Don Oliver, the pioneer of the four wheel drive tractor. Oliver along with Gale Stroh and Kenneth Bull using Minneapolis Moline tractors and parts created what has become known as
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
