Just spent a little time out in the shop now, and got the power steering stuff all taken off and cleaned up... Seals and all that look pretty good, hoses are fine... Will this setup fit onto my H? It is a Charlyn, there is a pulley that somehow goes onto the front of the crank shaft pulley. Resivor under the front left corner of the hood.
I think that I will just hang onto it, for when I get another M! Did they work all that well, or were they just kind of helpful once in a while!? :)
I was kind of surprised at how well the wide front end turned (schwartz). It turned fairly easy without the loader on it, and it turns VERY sharp! Might turn harder than my C!??
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farming Never Left My Blood - by Stan Gordon. I was born in 1947 youngest of ten of a working farm. Our farm was located in Saskatchewan near Saskatoon. We had a mixed farm consisting of grain and dairy all done with old machinery and by hand. My dad had a tractor, a Farmall A which was used mostly to run the thrashing machine, a seed drill and for plowing. I remember locals used to help each other and threshing was done from daylight to after dark, one farm to another until all farms were done.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
