Posted by farmboy48 on March 25, 2015 at 11:52:06 from (208.107.15.166):
In Reply to: News Story posted by Nathan (SD) on March 25, 2015 at 09:18:56:
I live in Williston, and there are so many jobs available here yet, even with the drilling decline, they may not pay 100k a year, but you would have to look hard to find one that pays less than $15 an hour, most entry level Wal-Mart, restaurant, fast food places even start you at $17 an hour. Biggest drawback is the cost of housing, they are putting up apartment buildings by the dozens, but rents are still in the $2000-$3000 a month range. You need a few roommates to come up with that much. A room in one of the man-camps will cost about $800 a week. There are several new eating establishments opening in the next couple weeks, and a new Menard's coming on line shortly, as well as several other businesses. They will all need employees, so the jobs are out there, you just have to want to work..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
