Posted by Bill VA on March 13, 2015 at 09:27:34 from (76.3.243.86):
In Reply to: Super 68 NH baler posted by oldtanker on March 13, 2015 at 07:21:48:
They are pretty easy to make - even with basic shop tools. If you don't want to make them, Best Baler Parts has reproductions for around $50ish.
With respect to oil - I'm listening, but when I pulled the wood slides from my plunger, they were oil soaked and soft. My concern with the oil is potential softening of the wood. I should think that at some point the slides would get a hard glaze and a spot of oil at the beginning of baling would be good. Just don't know about soaking - no way am I saying it's bad, just offering up my simple minded opinion/observation.
When the weather breaks, I'll re-install the wood plungers on my NH68 and see how it goes. One thing I'm doing while I have the plunger out is freeing up the knife - so I can sharpen/shim as necessary and replacing the pitman bushing at the plunger as mine has some wear/loosness.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
