jdemaris said: (quoted from post at 16:04:37 03/07/15) Last I checked, every town in the entire state of
New York is required to have an "animal damage
assessor." It is a requirement of New York
Agriculture and Markets. That being said, many town
officials - if you ask about it -won't have any idea
what you're talking about. None of the officials in
my town did until I forced the issue.
There are lots of things required by law that don't happen. Ag and Markets is one of the most ignored and contradicted sections of law in NYS. Every town is supposed to have a "Fence Walker" too. Not a one does, haven't since the 50's in this area. What I have seen happen is a local vet gets tasked with the job of your "Animal Damage Assessor". But it's not like it's a full time position. Ag and Markets is so far down on the hierarchy of law listing that it's not even taught to police officers anymore outside of a couple of specific sections. I had one of the last Ag and Markets references around and the contradictions and impossible positions it presented were staggering. So I wouldn't get to dependent on the Ag and Markets Laws being followed. For instance-The Ag and Markets says a farmer can shoot a dog running his livestock. There's another law that says no dog may be destroyed by gun shot, and yet the SP still carry a form specifically so an owner of a car struck animal can sign off and give permission for a cop to shoot a car struck dog, cat, horse,etc. Contradictory? Yup. Never, ever try to apply common sense to the law. The two are mutually exclusive of the other.
I've learned a lot since getting elected. One of the biggest things is that you simply can not make every happy. The other is that just because there is a law or requirement in place, doesn't mean anyone actually expects it to be followed! Adultery is still illegal under the NYS Penal Law. When do you suppose the last time that was enforced was?
This post was edited by Bret4207 at 06:25:04 03/08/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
