If you want to keep using your wood boiler to heat shop and house here is one way to do it tied to your gas boiler.If you want to go to a warmer climate in January, no problem. Just don't let your wood boiler or any piping freeze. The electrical is not shown in the drawings. I would say the boilers keep the manifold supplied with hot water. As the load removes the heat from the water the boiler or boilers will re-supply the manifold with their high and low limit controls.
I have a drawing showing zone valves used with this manifold system. To use zone valves you would need another manifold to mount the zone valves on and a pump to pull the water back into the return side of the manifold.
Another control would be needed on the Hot side of the manifold to power up the control to turn on the zone valve pump and open zone valves as the thermostat requires.
The one picture came from a Califfe, Idronics, journal of design innovation for hydronic professionals, #10
The drawing is how I want to re-plumb my system. The hydraulic separator and manifold piping are sized by Gallons per minute of the pump or pumps.
That second picture was put on by mistake. I do not know how to remove it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.