Posted by fixerupper on March 01, 2015 at 14:57:50 from (100.42.82.100):
In Reply to: Daylight Saving Time posted by wolfman on March 01, 2015 at 14:45:02:
The one thing I don't like about the time change is figuring out all the clocks. I admittedly am too much of a perfectionist where everything has to be set right to the minute. They all change in a different way. Back when I drove Chrysler products for the family car all we had to do was stick an ink pen in the H hole and the M hole to change the time. On our Sienna van it's the same way only we can push the little buttons with our fingers. The Colorado, however is a different breed of cat. I have to go to the owner's manual every time and then it depends on what 'sound system' I am looking at. The Colorado's 'sound system' is the cheap one that doesn't change automatically. The 79 Dodge, the 4650 and the 1086 all have radios that require a different technique for each one and the instructions are in the cab with me. Then there's the microwave, oven, two shop clocks, kitchen clock and the office clock. The bedroom radio changes automatically and so does the atomic clock in the living room. WHEW! lol
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Little "M" - by Donnie Anderson. They call me "Little M" and this is my story. For the past several years I have sat against the tree-line, where my parts have rusted and rotted away. For all of these years I have wondered just exactly what happens to old tractors? Times were not always like this. I can remember back to 1948 when I was a brand new John Deere Model M. A man and his wife came to the dealer and looked me over real good. After many talks with the salesman a deal was struck and I, along with a M2 plow, c
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
