Posted by Michford on February 25, 2015 at 16:31:07 from (174.124.234.76):
In Reply to: Re: Front axles posted by mazemeister on February 25, 2015 at 09:44:49:
There were at least two different aftermarket kits sold in the 1950's to convert a Ford 800 hundred series and the later 801 series with a MFWD. A company called Elenco used surplus Powerwagon front axles that were narrowed and flipped over to place the pumpkin on the left, and made their own mounting brackets and chain driven gearbox to supply drive to the front axle. Elenco was sold through Ford tractor dealerships and could be installed by a dealer. Another aftermarket company that supplied a kit was Napco who apparently partnered with Sherman to offer a MFWD kit based on a Dana 44 closed knuckle front axle. They also made their own mounting and chain driven gearbox as part of their kit. Their are a few pictures of Elenco equipped Fords in the photo section of this site. There are very few pictures of Fords with the Sherman Napco conversion and they are more uncommon than an Elenco conversion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
