Posted by Steve@Advance on February 20, 2015 at 20:01:53 from (107.203.134.67):
In Reply to: We were awesome!!! posted by Goose on February 20, 2015 at 07:25:19:
Yep,that all sounds familiar...
Never had a BB gun though, started out with a pump up pellet gun, wasn't strong enough to pump it very many times, so figured out dads 22 was a lot easier! I must have been about 8 at the time.
Only had a couple of bikes, found them boring once my cousin gave me his Montgomery Ward moped. Got it running, rode the streets for years on that thing! Helmet cost too much, just don't land head first!LOL
My favorite toys...Anything that ran on gas or electricity! Rescued a neon transformer from the roof of dads gas station! How much fun could a 10 year old have with that! Lawn mowers, electric motors, old TVs, everything was fair game!
Got my first car at 14, dad was going to sell it for scrap... No, no, no, I'll take it! I would sneak it off to school long before having a drivers license!
Well, I could go on, obviously I lived through it, so far... Still growing older, but not up! LOL
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
