Posted by The Dukester on February 20, 2015 at 09:55:57 from (204.106.241.43):
In Reply to: We were awesome!!! posted by Goose on February 20, 2015 at 07:25:19:
I was born in 1934 and went through most of those dangerous times and hazards mentioned.... and obviously survived. My question is....Why are we such gutless wimps and quietly puting up with what's going on in our once great country these days? (I know, I'm just an old senile rabble rouser and my remarks will probably get me kicked off this board....But, you know what? I'm being honest and real about the sad situation we Americans and a lot of the rest of the world are in as I see it). It's been a great 80 years I've had and I've enjoyed most of it...and I Thank God I lived it in the times I did....through all those unaddressed dangers and wars (most of which we won, or sort of won, incidently, shame on us) and some really hard times. The present future sure doesn't look so good to me now. We've come a long way...down the wrong road.....H--l bent for an election where there will be no winner...just losers, all losers.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
