You have to train them. Start them as puppies and never alone with the livestock till your sure they're ok.
My Pyrenese "Brie" was playing too rough with the lambs,chickens etc and injuring them. You have to catch them in the act and put a stop to it. I'm not seeing any injured youngsters so I think I'm past that now.
I never see any after birth since I've had her so she must be eating it.
Another bad behavior was to clean the lambs up and "protect" the newborn from momma. Not good. Again I caught her in the act and put a stop to it.
She has a taste for eggs and I believe once they have a taste your not going to break them of it. In my case I modified the hen house so she can't get in. I free range. I never se any eggs on the ground anymore.
If your dog is eating lambs it's time to get rid of her. Even if they were still born it won't be long till she's killing them.
Dogs are descendants of wolves that man has tried to breed the predator instinct out of. Apparently your dog has some predator left in her.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.