In principle, not much different than a walk behind or similar snow blower/thrower.
You will need a slow reverse, but conditions will vary so if there is enough power, you have made a decent match with a tractor, preferably one with a heated cab, they are quite productive. We had a 6' Loftness on a 33 HP challenger with a loader. Underpowered, and heavy, but it actually worked quite well, just by working with what you have. This tractor was hydrostatic, so speed was no issue. Aggravating without a cab, looking back does wear on you, but given the productivity of it, wins hands down vs using a bucket, and or a plow in many situations. Nice to have hydraulic chute vs manual turn. In all reality, cab tractor and front mount is much better, but for limited work, depending on winds and how much you can take, they will move and throw some serious quantities of snow in a short time. Even banks that are starting to set up. I like the set up with a loader on the front, as you can turn around break hard pack up, then clear it with the blower.
Not all that much to them either, so checking the chain and sprockets, auger bearings, gear box/oil etc., some fittings to grease on the chute etc. Most blowers perform poorly in wet snow, all depends on how wet if that can be measured. I plugged a walk behind for the first time in 13 years, with a wet sleet/snow that packed in before it turned to snow, and I've cleared lots of non powdery snow in warmer conditions, mostly it just won't throw it as far, can plug depending on how fast you go.
Look for worn chain sprocket, bent flighting/auger, check the cutting edge, skids, leaking gear box, no different than any other etc.
Safety, you had best shut it off if you need to look at it, visibility, make sure NO one is nearby when in use and obviously do NOT direct the chute towards glass like vehicle windows, house, barns, as projectiles will come out of picked up. Adjust properly, the skids, top link etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I�m handing him tools and he says, "give me that..." and I�ve already got it in his hand or "hand me that....."and I�ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
