built a 40x40ft addition onto my old 20x40 tool shed, 16ft high with a 24 ft wide overhead door facing west... heated by geothermal heat pump... costs about $250 a month in hydro to heat, which compares to $400 a month for the old tool shed with fuel oil (when fuel oil was 70c/litre)... spray foam insulation - it costs more by seems to be a lot better so far... 3/4 inch copper air line around the shop, 3 welder plugs 9one either side of the door and one opposite the door), 15amp plug ins every 8 ft down the 3 walls and one either side of the big door, and each wall has a 20amp plug in too.... lit by 9 6 tube t5 fixtures... would love it to be another 20ft longer, but it was all i could afford at the time... and i should have put a drain system in the floor!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
