Actually not. From looking at the temperature maps daily this winter, we have been colder than or as cold as other areas that usually seem to be quite a bit colder. One place that comes to mind is International Falls, MN. Seems to me if the temperature drops there, often times its headed this way. Snow accumulation is up to my knees at this point. Stark contrast from where you are Stan, I have been there many times. One has to appreciate that though, you can have both if you head into the mountains, here its months of one type of weather with no escape LOL !
It is however warming, the sun is getting stronger and is melting snow, the last bit we got that I did not clear, turned granular at mid day yesterday and the blower would not send it far at all. By this time, I've acclimated to it, so working outside is not an issue if you are moving around. Yesterday it topped off at 30 deg F, full sun, perfect for being outside, even the house is warm, furnace stays off most of the day here when the sun is out and the wood stove does not take much to warm up the garage/basement area, get below 20 deg F and that changes drastically. It will be about the same today. Looking back at photos, and about 5 days earlier we had exactly the same amount of snow on the ground, which took until March 11 to dissipate, per my photos. This winter is about the same, but I think colder as we have had more sub zero weather. You can see on the map where its warmed up further from the south, gradually.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
