Posted by paul on February 05, 2015 at 05:28:43 from (66.44.132.180):
In Reply to: Re: Bryce posted by Bryce Frazier on February 04, 2015 at 20:45:43:
I have very tough clay soil. The 960 pulled a 2-16 nice with fluid in the rear tires. It would not pull the 3-16.
Dad pulled the 3-16 with an Oliver 88 with lots of weight on the rear tires.
Folks in lighter soils often add a bottom more than what we are able to pull.......
Dad was sacred of SOS tinny back in the 70s; surprised everyone else is so negative, typically here people say how nice a tranny they are, often its just a band needs adjustment, etc....
Sounds like you have good experience with them, that would be a fun tractor to set in a corner of the shop and work on see how it goes if it were half the asking price.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
