Posted by Billy NY on February 01, 2015 at 06:51:44 from (104.228.35.235):
In Reply to: Re: Chains on ice posted by bja105 on February 01, 2015 at 06:45:47:
They will help, add weight, loaded tires or something on the back end also makes a big difference in traction. Flat ground makes a difference too, working perpendicular to a slope, in my opinion can be a pain sometimes, a lot more so without chains, weight etc.
If you can jack up a side of the tractor, you can pull up on the end of the chains a bit, get them started on the tire, then roll the wheel til they drop off the other side, then pull together to connect. A small load binder can help cinch them up, I prefer to do it that way myself, but am, not opposed to laying them flat and driving onto them and pulling up each end, either or, they're a bit heavy at times, (double ring) they're usually not too difficult to install, and should not take more than a 1/2 hour once you've done it a few times.
I bought a new set of 13.6x28's, with the tensioners for each side and the silly load binder from tire chains dot com and it was about the same as what you are going to spend. They made quite a difference in snow with ice under it. Eventually they will slip the tires if you try to push a substantial load, ie; snow bank or similar.
If you plan to run strictly on ice, V bar on a set suited for ag tires might be the best choice, but for most, myself included double ring snow chains will work quite well from deep powdery snow to hardpacked and ice conditions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
