I use 3ea 55 gallon drums that I have lashed into an old GMC short bed trailer made from the truck. I got my pump from TSC but have seen the one you are talking about in NT catalogs. I stuck an old battery adjacent to the drums and charge it every once in awhile. Doesn't take much juice to run the pump.
I fill the barrels, leaving expansion room obviously, and cap them up tight except for the one I'm using in which I leave the pump. 3 barrels with air space at the top fall under the requirement for a haz mat sticker on the trailer so I don't have to fool with that. Annual trailer license for farm use is 5 bucks.
It sits under a car port I built keeping the tanks out of the sun and rain but within easy reach of my tractor.
When it's time to fill her up, just latch on to the trailer and go and get it. I got tired of hauling them in the back of the p/u and having to lift them out and back in every time I needed to fill them.
In case you're interested, for the lifting device, I installed a girth chain around the drum that wouldn't slide up over the ridge. I then added enough chain to make a loop connecting each side of the girth. I have a hook on my FEL bucket and would use that to lift them out. Now I don't have to fool with that.
Go for it.
You could also mount a larger single tank in the trailer but would need a haz mat sticker. I had the drums so that's what I used. Mark
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
