When I first started helping my Dad we had a hired hand and always had two tractors the same.The first ones I actually ran not just drove were SMTAs and we pulled 3 bottom plows planted 4/38 rows.When I actually started farming with my dad my first tractor was a 1206[reason I like 1206s] which pulled a 6 bottom plow and we planted with 2 separate 4/38 planters with part time help.Then We switched to JD went to 30in rows started with 6 and today plant 24.Our first 4WD was an 8630 that pulled an 8 bottom plow and was nice but was beginning of update after update from front to rear.Not on the 4WD but we put close to 900 hours per year on our row crop tractors.Fast forward to 2010+ we use 500+ track tractor about 350 hours ,the combine gets around 300 separater hours my 8330 planting and grain cart tractor also gets around 350 hours and my loader tractor we use most everyday for livestock gets about 750 I wonder how we were able to get everything done.No wonder some of the farmers spend so much time at elevator or coffee shop.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
