Are You No-tilling, or tilling? I prefer to do it the old fashion way... 1) Plow 2) Disk pulling Cultipaker/Clodbuster behind. 3) Broadcast Fertilizer. 4) Disk 2nd time pulling drag harrow behind 5) Broadcast seed 6) Drag harrow.
I don't like planting No-till hay. Ground is left to rough for my blood. But it is doable! If You don't have the equipment then no-till is really the only way top go. USDA does, or did rent smaller drills, or seeders. I forget where it was; but over Christmas I saw a 10 foot JD 750 no-till drill in a USDA parking lot. But they take a lot of HP to pull. About 12 hp/ft (If memory is correct). 120hp for a 10 foot drill. I remember a sales person laughing at me when I asked him about a JD 4430 pulling a 15 footer. That was almost 20 years ago.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
