Posted by Texasmark1 on January 14, 2015 at 07:36:40 from (99.197.214.247):
In Reply to: Re: Drones Again posted by Texasmark1 on January 14, 2015 at 06:50:23:
Oops. BIG error in post. Bullets (rounds) are 30 Millimeters in diameter, not 30 Caliber. Let's see at 25.4 mm/inch that makes them1.18" not 0.30". There is a video of the A-10 firing it's Gattling gun on U Tube. Not real clear from a target's perspective, but what amazed me was it's ability to deliver it's ordinance and well before it reaches the target, do a fast pull up and U turn. But, just like a short tongue trailer, with the wings set as far back as they are it makes for a tight turn and the pilot has pretty much unlimited visibility. The pilot sits in a Titanium tub which shields him from 3 sides and below.
If you Google Davis Montham AFB in Tucson, you can see some of them in storage. News says that numerous have been pulled out and put back in service against the new problem in the Middle East.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
