Posted by Spook on January 13, 2015 at 19:30:31 from (99.103.114.48):
In Reply to: OT Dumped Dish posted by Pat Sublett on January 13, 2015 at 14:16:24:
Pat Sublett said: (quoted from post at 15:16:24 01/13/15) Dumped Dish today. I don't watch more than 2 or 3 of the 200 + channels on Dish and Fox is one of them. They have had plenty of time to resolve the issue so I cancelled Dish today and sighed for Direct. I hate to sigh a contract but enough is enough. My next move is going to be a rinky- dink antenna.
I've had both, I felt Direct TV is a little better, we had a equipment failure, they replaced it in 1 day. Dish doesn't seem to have much support, we had the same kind of failure with them, it took over a week to sort out.
By the way, they have Fox, MSNBC, CNN. I like Cramer on MSNBC and the financial stuff they have. A low key alternative is the Bloomberg financial channel, very informative. I watch Fox occasionally, but for financial stuff, I prefer the other channels. IMHO, the fox financial is too political.
This post was edited by Spook at 19:34:56 01/13/15.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
