Posted by Notjustair on January 09, 2015 at 18:16:15 from (70.195.0.27):
In Reply to: JD 4630 posted by young tractor on January 09, 2015 at 10:48:02:
I sold one of the 4440s this spring for 18,000. It was pretty cheap, but I kept the best 4440 for me. I love them. They are/were both quad range. If they have been used as they should they are bulletproof. There isn't a lot to go wrong on them if people have clutched between gears and stopped between ranges. I'd get another in a heartbeat. I regretted selling the 4440 about three days after I did and tried to get it back but it was too late. I didn't need it anyway as I had bought a 7800 to replace one of them. The one I kept has 9500 hours. Still runs like new and uses no oil. That 466 is a pretty darn good engine. The only one I have had rebuilt was the one in the 8430, but it is turned up about 100 horsepower more and works pretty hard. If I remember right it was done about 9000 hours. I got the 4440 to pull a 36 foot disk once (when the 8430 needed the rebuild). It is the only time I have ever seen the temp guage move off of the cool side. She worked pretty hard but pulled her own.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
