Posted by Steve@Advance on January 08, 2015 at 20:53:12 from (107.203.134.67):
In Reply to: OT: truck oil pressure posted by LOU from Wi. on January 08, 2015 at 19:36:52:
I can't imagine how the backfire would change the oil pressure.
Possibly while in the distributor the point setting changed (those distributors had a bad design on the point plate, plastic pivot for the vacuum advance would wear/break causing the point adjustment and timing to vary) and caused the idle speed to go up.
Is the running pressure high too? If so, the pressure relief plunger may be sticking. Keep a close watch on it, if it sticks closed the pressure will go up, blow the oil filter or twist the pump drive shaft off.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
