Posted by Case JI 530 on January 03, 2015 at 08:06:19 from (66.103.32.49):
Hi
I was wondering if someone could answer a question for me.
I have a 1968 Case JI 530 Tractor and I had to put another distributor in the tractor and now I have to set the timing because everything is out now.In my manual it said to (INSTALLATION AND
TIMING. To install the distributor,
crank engine until number one piston
is coming up on compression stroke and
continue cranking until the static ignition (IGN) timing mark on flywheel
rim is in register with pointer in
timing port on side of torque tube as
shown in Fig. 102.
With the rotor arm in the number
one firing position, install the distributor. Rotate distributor until breaker
points are just starting to open and
tighten the clamp.
The problem I have is that there is NO IGN mark on the flywheel it just has a DC mark and then timing marks 10' 0' 10'20'30'40 . Do you now where I should set my pointer to on this flywheel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Collection of a Lifetime - by Sherry Schaefer. The larest gathering of orphan tractors ever assembled by one collector will be auctioned off on May 15 in Rock Island, IL. Ed Spiess was a well known tractor buff who spent most of his time dreaming of rare and unknown tractors. His background as an agricultural engineer sparked his interest in the unique attributes of the models built from 1939-1959.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
