Posted by George Marsh on January 02, 2015 at 14:12:06 from (50.104.121.187):
In Reply to: Re: Gray quest posted by old on January 02, 2015 at 10:24:49:
Old, I never heard of Shark-bite fittings. Menards carries a push in connector that fits plastic, copper, and the quest replacement flex plastic. Expensive and I've had issues with it if copper has just a little pit in it.
I had a place that was a mix if iron, hard copper, soft copper, and plastic. It got so bad, I replaced everything with cpvc.
That said, it was a practice in older homes to use iron pipes to attach a ground wire to. I know of a case where a kid was killed by touching the outside faucet. I wonder if at one time the plumbing in the house was all iron, which someone used it as a ground. Then replaced some of the iron with plastic. The faucet was no longer grounded. Boy ends up dead. Only speculation on my part what actually happened. Something to think about.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
