Posted by sparktrician on January 02, 2015 at 06:44:25 from (70.208.201.16):
In Reply to: Electrical project posted by Nathan (SD) on January 01, 2015 at 14:36:22:
I think what you are trying to get at is how many current carrying conductors can you put in a conduit? The fill chart you found just says how many will physically fit......but there are other considerations......
The 2014 code book (just what is sitting close here) says up to (3) current carrying conductors (this includes neutrals) at 100% rating. 4-6 at 80%, 7-9 at 70%, 10-20 at 50%.
Basically, the more CURRENT CARRYING CONDUCTORS you put in a conduit, the bigger the wire. Now, if you use #12 wire on a 15A breaker, you have effectively de-rated it.
Generally speaking, this is not a huge issues in most installations (although it can be)
IF these circuits are for general purpose receptacles, the likelihood of them all being operated at "capacity" is small.
If these circuits are for dedicated appliances/machines/equipment that will operate at or near capacity.....you better look at it.
I have seen a guy TRY to run a 2" PVC through a hog barn and pull EVERY branch circuit through it (trunk line with lots of boxes) Most of the circuits were loaded at capacity......when that mess was over, the pipe came out with the wire in it still......all melted together in one gigantic mess.....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
