Posted by Kirk Grau on December 31, 2014 at 14:01:40 from (98.235.64.137):
In Reply to: Re: Eeeewwwwww! posted by Straw Boss on December 31, 2014 at 13:25:33:
Been watching this today without a chance to reply. My suggestion was going to be that code requires a minimum size (I think 3") to prevent frost closure just as you are seeing so I'm surprised to see that you do have a 3" VTR (Vent Thru Roof). Can't say that I have ever seen anything like that around here.
You are also correct on the dynamics of what is happening once the vent frosts over that the lack of air is creating a vacuum and sucking the water from the traps.
Google Air Admittance Valve. My suggestion after seeing this would be to cut the vents below the roof and use the air admittance valve. Some codes don't allow them, but they would sure work in your situation. If you don't want to have to repair the roof you could probably "wye" into the vent pipe below the roof and put the AAV on that line.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
