Posted by Leroy on December 30, 2014 at 09:49:08 from (69.88.207.185):
In Reply to: How Many Will Fit? posted by Bryce Frazier on December 30, 2014 at 07:51:47:
Bales 36" long load for 5 bales per teir and length would be correct for 4 tiers long so 4 teirs high of the 5 bales on a 14" bale would be 6' 2' load height for 4 bales high then a tie on top of those 2 wide and half overlaping would be 7 bales per side or 14 total ther would be 25 per stack times 4 stacks equal a hundred plus those 14 on top to tie together is 114 bale and at 50$ per bale that is 5,700 pounds and would make your total load height 7'4" and with a bed 3' off ground that should be high enough for a lot of doors and the like, low branches and things. You are tall (for short person you would not want that extra height) so loading a layer higher if you have the overhead clearance might work and that would add 20 more bales or anouther 1,000 pounds. So that would make 6,700# or over 3 and a quarter ton. Your truck is rated ot what 1 1/2 ton or is it 2 ton. Either way it should hold that much but it will be a full load on it. The 2 straps lengthwise are good but also add 4 more crosswise over the load so it doesn't shift sideways as it can with just the 2 straps lengthwise. In my 71 years I have seen too many loads lost because of not being tied down good enough. And make that front end for the bed and make places on it to fasten those straps to toward the top of the load.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
