Posted by prawn farmer on December 23, 2014 at 05:17:29 from (107.77.87.115):
In Reply to: sliding barn doors posted by jtex on December 22, 2014 at 14:52:19:
Assuming that this is a pole barn . . we made vertical "jamb-extenders" out of ripped, treated 2x6's. Attached them by pre-drilling the holes in them and attached using 60d ring shank nails. Above, we used a horizontal track board attached to the end-wall truss or on the header if in sidewall. These boards, or extenders, allowed the door to slide by the ribs of the sidewall metal. To keep the door from blowing out in a wind, we used stay rollers attached to a treated 2x4 nailed to the face of the bottom skirt board and then used either cam lock or chain snuggers to keep the door tight against the jambs. The sliding door has to be wider than the opening, of course, so a 36 ft wide building with a 18ft endwall door would actually have a 17'-9" opening size. There are several good brands out there of the cam locks or rod/chain snuggers. We used mostly Plyco but Cannonball and A-OK were good, too. Very little problems, if ever, with rain or snow.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
