Posted by Jiles on December 11, 2014 at 20:15:04 from (69.137.29.28):
In Reply to: 13,500 RPM Redline posted by Richard G. on December 11, 2014 at 15:16:31:
Quoting Removed, click Modern View to see
Yes, and some other brands turn higher.
I do a lot of chainsaw repair and I do not tune by holding the throttle wide open while adjusting the "H" carb screw.
This is recommended by most everyone but I do not see any sense in following this procedure.
The way I do it, is to hold wide open until it reaches max rpm, let off and do another adjustment and so on until it "fouurstrokes" (slight fluttering of exhaust). I then further adjust accordingly to make sure it doesn't fourstroke during the cut.
I follow this procedure because I know what's going on inside the engine at that RPM!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
