I have worked with quite a few deputies and city police officers, one of which is a firearms instructor at the law enforcement academy here in Iowa and two are instructors/armorers for their agencies. Most carry concealed when not on duty. When asked why the reason I have been given... it gives them options. Not showing allows you to blend in and be just another Joe. Sometimes getting details of a suspect, vehicle, which way they took off, etc. can be more beneficial to on duty officers and less likely to escalate a situation and more harm brought to others. Here in Iowa, you are not to unholster a weapon unless you have to eliminate the treat... this means no brandishing, warning shots, shots to injure... all will result in you being in trouble with the law yourself. Open carrying can present you as a first target in an event where shooting occurs... an armed citizen is of no use when they are the first taken out. There is also the paranoia factor, when people carry concealed the bad guys don't know who might be around that will stop them.
I personally have no issue with others openly carrying, if done so legally. In fact I may go strike up a conversation, find out what is in the holster. I have known a couple who wanted the shock factor or had the "I'm a bad a##" attitude you mentioned, I tend to steer clear of these folks, as this is not the reason to carry and puts all of us in a bad light. Myself, I may or may not take the element of surprise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
