Posted by Dave H (MI) on December 02, 2014 at 13:49:58 from (50.108.114.101):
In Reply to: IT'S DONE! (almost) posted by RayP(MI) on December 02, 2014 at 11:04:16:
That's nice Ray! I know why it is 96' long because of steel sizing, but what is with the 48' width? Isn't that an oversize truss? I was told that if I went over 40' wide the truss cost went up a lot. Mine goes up next month. 40'x96' with 16' walls. Two 10' sliders on the end so the combine will drive in and give me plenty of room to move. I am putting the service door around the corner so the sliders don't cover it. putting a second slider on the long side also. I am also using a scissor truss to boost the headroom inside a few feet. Hopefully won't bump my head if I am on top of the combine. Need more details on yours! Won't ask what it cost...I already have a pretty good idea.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.