I think that I am on the trail of a bad valve... I had an interesting idea, and that would be, that if the arms have trouble going up due to a piston related problem, such as rings, or just a lot of wear, then the arms would come down quickly, because they couldn't hold pressure.
Well, I fired it up, and let it take it's time to get the arms ALL the way up to the top, I am sure of it, couldn't pick them up anymore. Then I shut the machine off, and just sat there and watch to see what would happen. I instantly heard a weird bubble noise, I look in, and below the pto shaft, air is bubbling up through the oil? So I go around and stand on the lift arms. They start to go down, in surges, and for evey surge there is a LOUD bubble in the oil. It went down about 2 inches, and then stopped. From this point, 400lb's couldn't make them budge.
So, if I am correct, that should eliminate any possibility of a piston related failure, right??
If that is the case, then I figure that it must be a valve, or the pump just can't get enough oil, but then how is a person suppose to explain why it does go up very well at first, and then it all falls apart????
Getting close, I can taste it...
However it tastes like 80-90... EEEWWWWWWWWWW!!! :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1929 McCormick-Deering 10-20 - by Randal Simmon. On July 4th 1998 my dad and I was sitting on the front porch when he said that he was going to sell his two 10-20's to a junk man. He said that the junk man was going to give him $500 for both of them but he hadn't received the money for them yet. So I went into the house and wrote him a check for $500 and bought them myself and said now they are mine. He had bought them about five years before thinking that he was going to restore them himself. After five years sitting in the barn, he changed h
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
