Posted by Bill Va on December 01, 2014 at 08:26:07 from (76.3.243.86):
In Reply to: John Deere 350 Rake posted by Bryce Frazier on December 01, 2014 at 06:36:01:
I bought a JD350 rake this summer. Mine is a 4 bar rake and the only thing it needed was a new belt, which I got at NAPA.
We used it to rake 12 acres of hay and did that two times at least on our only cut - late summer. I bought a manual from ebay and in it there is a provision for this rake to be used as a pull behind - that might be what you are seeing. Mine is also a 4 bar rake, but can be converted to a 5 bar rake too.
3 point is nice as is the PTO as you can lift the rake over windrows and adjust your PTO independent of the ground speed. Mine is a perfect match width wise for my 7ft sickle bar mower.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
