Posted by nebraska cowman on November 30, 2014 at 14:07:16 from (166.182.3.232):
In Reply to: What size LP snow blade? posted by thephantompatriot on November 30, 2014 at 13:25:18:
Let me give you my two cents (which will be worth just what it costs you) I've plowed lots of snow with a Ferguson 30 (pretty comparable with your 354) That landpride in the pic is WAY more blade than you need but if you want to spend the bucks fine. Yes, a 7 ft is sure all you want. A 6 might actually push more snow. But you are going to find out right away that the tractor won't push much. Especially with the blade turned around so it cuts in. The way to push snow is to back up with the rear edge of the blade back so it rides over knobs and does not dig in. On your finish pass you can leave the blade the same only do your work going forward. In light snow you may be able to do all your plowing going forward but be aware, too much snow dragging ahead of the blade can get you stuck. Of course on cement or blacktop this advice may not apply. I routinely plow my cement parking lot with my little 154 Leyland and the 7 ft blade facing rearward. I do have to watch out for any lips of cement it can catch on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
