Posted by Steve@Advance on November 24, 2014 at 20:51:38 from (107.203.134.67):
In Reply to: farmall c oil pump posted by don dennis on November 24, 2014 at 16:04:46:
A couple of concerns, installing the pump cover without a gasket would have decreased the end play clearance on the gears. If the gears are bound up against the cover, they will gall against the cover and inside of the pump housing. This will cause reduced pump efficiency, and will release metal shavings into the engine.
Hopefully that didn't happen! But just for peace of mind, might be worth taking a look at it.
Also, where is the pressure relief valve? Possibly silicone or metal shavings have found their way there. If it s built into the pump, take it apart and be sure it's free and properly assembled. If it is accessible from the outside of the engine, same thing, be sure it's working properly. If it's stuck partially open it would give the same symptoms you describe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
