Jason S. said: (quoted from post at 14:48:10 11/22/14) I have been reading the Oliver plow book which was published in 1920 ,but it is still a very good read and has some good points in there. It tells in there that depending on where your soil fertility is tells you whether or not you need to plow shallow or plow deep. It gives other reasons also but I am using that one example. So how many of you own more than one plow for different reasons? Like me, I have a Massey #62 two 14" that I am converting over to a three bottom. It is a good general purpose plow. I have an older Ferguson two 12" plow that I bought to go to plowing shows, but it has the moldboards with a very sharp curve to them,so it does bury sod better than the general purpose moldboards on the Massey plow I have. I also own a Ferguson Disc plow which is just the trick for plowing corn fields,never plugs up...I also have a lot of rocks so it is good for that reason also. I also have a Farmall A-151 disk plow to go with my Farmall Super A. It was give to me was the reason I have it. I also have a Ferguson 9 shank tiller, or field cultivator as some call it. I actually find it to be one of the most usefull plows I own. Any of you have more than one plow for different reasons?
Father's old JD 555 4x14, a model 45 3x16 and a model 415 2x12" with 14" bottoms. All with trash boards, extensions and root cutters. Considering adding the weed hooks. There is a model 2600 JD 4x16/18/20" in the shed too.
There are times when nothing breaks up clay like fall moldboard plouging.
This post was edited by buickanddeere at 11:32:09 11/22/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
