Posted by hot wrench on November 18, 2014 at 15:49:36 from (208.114.152.144):
In Reply to: Leveling Dirt Driveway posted by nebraska cowman on November 17, 2014 at 16:04:19:
nebraska cowman said: (quoted from post at 22:04:19 11/17/14) Actually a back blade works pretty good if you know how to use it. You say it digs in. Are you trying to back up with it? Normally it is hard to get a back blade to dig enough. I always run mine at an angle and run the inside higher than the outside to build a crown in the driveway. And the best time to work it is just as the frost goes out in the spring and it gets firm enough it's not just soup. Work it often then, probably every day for a few days and you will build a firm bed that will last all year. And then don't drive your car too fast, speed is what makes washboards. And if there is a puddle or rain water in a place, for goodness sake drive around it. Driving through puddles just makes them deeper.
Good post nebraska cowman, well said, very good advice.
And yes, you gotta have a crown.
This post was edited by hot wrench at 15:56:00 11/18/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
