Posted by Texasmark1 on November 13, 2014 at 11:29:18 from (172.243.93.14):
In Reply to: Re: OT-Well houses posted by Mike M on November 13, 2014 at 10:13:14:
When did that happen; the "gubberment" banning incandescent and what for? We can still buy them down here in the Republic of Texas, or is it back to Tejas?
But they are 40 watt appliance and 60-75w soft whites readily available. Can't find a 100w or so any more, but I think it's because they are replaced with the 26w neons, 100 incandescent replacements, of which I use a lot and like the low wattage, but sometimes need the heat the incandescent gives.
On the house, insulating and keeping the wind out makes a heck of a difference and a 100 w bulb will keep it toasty way down there in temp. Your #1 enemy is wind, same for your house....stop the leaks #1.
On using an infrared heater or anything, you have to input more "calories" of heat than the weather takes away and if it's cold and the wind is blowing onto what you are trying to warm, that becomes a problem.
Other thing is fire. You don't want to wrap everything up nice and cozy, put in a heat source and catch the whole shebang on fire.
What does work is a 120v heat strip/tape which usually kicks on at about 45F and has like 25w per foot. Hard to set that on fire or melt anything even with a double wrap and insulation over it.
Big box and hardware stores sell them in various lengths. Put that on your pump and what all and wrap your insulation around it including rainproofing.
Really after you factor in all that, especially moisture and wind intrusion, an insulated box and bulb is really simple.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.