Posted by Bob Bancroft on November 08, 2014 at 17:55:09 from (67.142.162.22):
In Reply to: Governor Linkage Spring posted by Brian G. NY on November 08, 2014 at 16:43:47:
Very nice. "A picture is worth a thousand words". Several points that might help the confused. The upper picture is the smaller block arrangement- B/C/CA/D10/D12/D14/D15/etc. With governor spring mounted externally. Different calibrated springs for each series give different wide open speeds. Proper gov. to carb. indexing is achieved by bending the cross arm!(Both wide open at the same time).
Lower picture is the bigger block- W series/D17, with internal gov. spring. Indexing achieved by bending vertical portion of gov. arm.
Little anti surge spring on left side of engine mounted or used as necessary.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
