There is over 200A of woodland on the farm. The sugar bush is 60A and has sustained that operation for near 100 years. My dad was a conservationest, and also very frugal. When a tree was desten for the wood pile, it all went into the pile down to limbs an inch in diamiter. He was also very careful to not cause colateral damage to surounding saplings in the woods. I am the same way. My cousins on the other hand just go in the woods with big farm tractors and don't have much reguard for new growth trees. I have conserns about the future of the sugarbush, but I will probably last as long as I do. When we start cutting wood for the evaporators next week I will cut alone in an adjacent woods and they will haul it out as I get it made. They will continue cutting in the sugar bush. If I work with them, I have to remember to bite my tongue and that makes my blood pressure rise doesn't make for a good working team. Loren.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.