Posted by CGID on October 28, 2014 at 10:14:38 from (65.129.3.118):
In Reply to: wood chippers posted by 55 50 Ron on October 28, 2014 at 09:33:34:
I've got a 10 horse Troy-Built. I've used it for seven years and it is reliable. It has a wide chute for leaves and twigs 3/8 inch or less and a narrow chute for wood up to 3 inch. It will handle leaves and twigs as fast as I can dump them in. The wood chute is narrow so a limb must be pretty straight to make it past the hole at the chute's bottom. A failing of the machine is that it takes a long time to chop up anything near 3 inch dia. Unless wood chips are needed for some reason, it's not a good use of time waiting for the machine to chop anything near its capacity. If you have limbs to chop up, be looking for at least a 15 horse machine or one that will run off of a PTO.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
