If I didn't already have a well constructed, rugged 3pt hitch splitter, I would buy a self contained one.
I too usually split by the "Armstrong Splitter" method, as my dad used to call it. Normally I have wood that is fairly straight and decent. However, I have had logging crews here at the farm for the past two summers, and on another large wood lot several miles away for the two before that, doing selective cut and forest improvement. They have left me copious amounts of firewood, tree tops, twisted stuff, anything that wouldn't work on a grapple load, hardwood pulp, pallet wood, etc. Some of the pieces are too big for my 24" bar to cut through. So I am forced to use a splitter on much of it.
Picture was taken of the last of 3 log landings about 30 minutes before they shut down the slasher/loader for the last time. The wood along the tree line is the smallest/straightest I have to deal with. Other landings have probably close to 30 cords of really ugly stuff.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
