What is an ideal length for a flat bed for hay? Right now, I can barely get this one turned around, and I think that it is way too long, but I hadn't thought about hang over... If I use 4x6 for the stringers, how much could those safely hang over the front and rear? Or should I use 4x8's? I will have to take a few measurements for the front, so that the bale chute and edge of the trailer line up, but I would like the running gear to be centered under the deck..
I figure, if I had a 12 foot deck, on 9 foot running gear, that would be 1 1/2 foot over hang on each end, which would be about right for the baler, I think... I still have to come up with another set of bale chute's, but that shouldn't be too bad..
I'll go out and take some measurements now, and let you know what I find...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
