Posted by cannonball on October 08, 2014 at 05:31:07 from (75.88.221.96):
In Reply to: drawbars posted by Mike(NEOhio) on October 07, 2014 at 19:24:23:
This is the draw bar on a Deere 4230
Specification Weight: 41.80 LBS 18.96 Kg Hole Size - Tractor End 1.024 IN Hole Size - Towed End 1.141 IN Length 44.748 IN Thickness 1.375 IN Width 2.500 IN No. Holes At "A" Tractor End 6.000 Hole Location - Tractor End 1.114 IN Hole Location - Towed End 1.252 IN Length to "J" 6.378 IN Radius 0.500 IN Offset 2.500 IN Material 4140HR Finish A Note
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
