Posted by Janicholson on October 05, 2014 at 08:45:31 from (74.60.94.18):
In Reply to: Mounting up on the left posted by Gary Mitchell on October 05, 2014 at 08:16:50:
It just may do so. Interesting. Examples come to mind: Motorcycles have kickstands on the left, and I don't think I have seen operators of motorcycles get on from the right (exceptions are dirt bikes when picked up and jumped on after a spill) Driver doors in the US and where drivers are on the left side also place leftness into the system. Combines have ladders going up from the left (all that I have seen) Commercial Airplane passengers enter the left side of the craft, as do pilots for general aviation planes with side by side seating. I rarely mount my bicycle from the right side. Boats (small craft) seam to be an exception, with pilot stations on the right. Unicycles from the rear!!!! I get on all our tractors from the right rear, or right (utility style) Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.