Posted by Indiana Ken on October 04, 2014 at 18:19:57 from (66.249.228.8):
In Reply to: Homemade Super Charger posted by 60 acre hillside on October 04, 2014 at 05:57:12:
Quoting Removed, click Modern View to see
The air flow through an engine can be estimated by the following:
CFM = ((Displ x RPM) / (k x 1728)) x Efficiency
Where:
CFM = Cubic Feet per Minute (intake air flow)
Displ = Engine displacement in cubic inches
K = 1 for two stroke engines and 2 for four stroke engines
Efficiency = A measure of how well the engine fills the cylinder on each intake stroke, in percent. A very high performance engine may be 80 - 100 percent. A tractor may be more like 50 percent. This is pretty much a guess unless you have data or data on similar engines.
Most engines should be able to handle 3 to 4 Psi of boost without problems however, this is not a guarantee. I would not expect a vacuum to output any where near this pressure level but, I have not seen your vacuum cleaner.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
