Posted by Bob N.Y. on September 27, 2014 at 04:49:00 from (72.10.212.122):
In Reply to: Re: Pilot bearing ? posted by Hobo,NC on September 26, 2014 at 19:23:24:
The clutch went out of this truck March 2013. It appeared that the studs that hold the Y-pipe to the manifolds had never been touched. I didn't have the means to deal with them so I took it to a local garage. The engine got tired shortly after that (221,000 miles) and I acquired another vehicle so I took it off the road. I had another engine that had been rebuilt. My mechanic daughter is here to help me change engines. I didn't notice the missing pilot bearing until I was putting the flywheel and clutch on the fresh engine yesterday. I have seen cases where the needles are gone but the shell of the bearing is still there. There is NO trace of a bearing in this one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
