Posted by GeneMO on September 21, 2014 at 08:30:11 from (71.51.203.52):
In Reply to: OT Gun Safe posted by pat sublett on September 21, 2014 at 07:09:38:
Dont know if mine is 1000 lbs or not. I had a good strong helper and we just "walked" mine across the floor. Tilt it one way, twist it in the direction you need, then go to the other side and repeat the process. You have to be careful of the flooring. Mine is a concrete floor with vinyl floor covering. It didn't hurt it. I think we laid down some thin plywood now that I think about it. To protect the vinyl.
I Made a pedestal to set mine on. 2X8's with 3/4" plywood top. Then trimmed it with oak. I wanted a moisture barrier plus wanted it a little higher off the floor.
My intentions are to bolt it to the wall, but haven't gotten that done yet.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Argyle and Mt. Pleasant Labor Day Weekend Shows - by Cindy Ladage. The last fling before summer fades into fall and we get busy in the fields are the annual Labor Day tractor shows. Beginning on September 5th and running through the 7th, the Argyle Antique Gas and Engine Show is held at the Argyle State Park. Located in West Central Illinois, the pine forest was the setting for the opening of the 22nd show. This year we decided to try to sell a few tractor parts, literature and wrenches to offset my husband's buying sprees. Saturday
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
